JOGGLER

A useful tool for working car body components. The combined tool can be set for either punching or bending. Available with Ø 4-8 mm punches and dies as standard.

Available with punches and dies from Ø 2-8 mm, in 1/10 mm graduations.

Available with punches and dies from Ø 2-5 mm, in 1/10 mm graduations.

Available with punches and dies from Ø 2-5 mm, in 1/10 mm graduations.  

For punching of guards. Can be supplied with punches and dies from Ø 4-8 mm.

Available with punches and dies from Ø 2-8 mm, in 1/10 mm graduations.

Available with punches and dies from Ø 2-8 mm, in 1/10 mm graduations.

A combined tool which can accept two punches of different diameters. Available with punches and dies from Ø 2-8 mm, in 1/10 mm graduations.

Punching tool for oval holes 5 x 12 mm, 6 x 12 mm or   8 x 12 mm as standard.

Punching tool for oval holes 6 x 20 mm or 8 x 20 mm as standard.

Available with punches and dies from Ø 2-8 mm, in 1/10 mm graduations.

Punching and embossing in one operation. Special for Ø 4 and 5 mm pop rivets, or as required.

A useful tool with hand-wearing rubber grips. The increased leverage makes work easier.

For working of small sheet edges - guards - panels - doors - parts etc. Bending tool - a good investment for bodywork repairs. The tool head is designed to enable folds to be made where the plate edges are very small.

For curves.

Applicable to edge folding for bodywork welding. The possibility for protection against rust on the underside of the plate is an added advantage.

For joining sheets. Applicable for welding or gluing replacement panels on to bodies. A nylon pad prevents deformation of the flange on the outer side of the sheet.

Adjusting tool for vehicle door locks.

Adjusting tool for vehicle door locks.

Available with punches and dies from Ø 2-8 mm, in 1/10 mm graduations. An easy and useful puncher for thin plate work.

A combined tool which can accept two punches of different diameters. Available with punches and dies from Ø 2-8 mm, in 1/10 mm graduations.

The ideal tool for bodywork component applications. The tool can rotate for optimum working position. Available with punches and dies from Ø 2-8 mm, in 1/10 mm graduations.

Accurate punch guides enable e.g. oval and square tools to be mounted. Available with punches and dies from Ø 2-10 mm, in 1/10 mm graduations.

Available with punches and dies from Ø 2-10 mm, in 1/10 mm graduations. Special form punches, e.g. oval and square, also available

The ideal tool for punching holes up to Ø 10 mm. Available with punches and dies from Ø 2-10 mm, in 1/10 mm graduations. Special form punches, e.g. oval and square, also available.

The combined tool head accepts two different punch sizes.

As easy and useful puncher for thin sheet work. Available with punches and dies from Ø 2-8 mm, in 1/10 mm graduations.